The correct installation method of the magnetic flap level gauge

1. The tank and trough where the liquid level gauge is installed must be non-sealed.
2. The magnetic flap level gauge should be installed vertically on the container, with a vertical deviation of less than 3B.
3. When wiring, be careful not to let the cable come into contact with high-temperature objects.
4. Confirm that the specific gravity of the medium is consistent with the specific gravity indicated on the level gauge's nameplate.
5. The rising speed of the level gauge should be ≤ 10mm/s.
6. During installation, no foreign objects are allowed to enter the cavity of the magnetic flap level gauge.
7. The magnetic switch operates by sensing magnetic lines of force. Therefore, when installing, be sure to avoid magnetic fields or magnetic conductive metals within 100mm around to prevent interference with normal operation.
8. When the load of the magnetic switch is an inductive or capacitive load, a RC circuit should be connected in parallel at the contact ends to protect the contacts.
9. Before powering on, please recheck the wiring to ensure it is correct to avoid accidental damage to the magnetic switch.
10. During installation, avoid severe impact on the magnetic switch to prevent damage to the internal float ball.
11. The power supply voltage of the transmitter is 24VDC.
12. When disassembling the level gauge, loosen the screws of the lower flange, remove the float ball for cleaning, and install it back, paying attention to the symbol on the float ball should face upwards. If the float ball is a custom product without a symbol, please install the end with the heavier magnet facing upwards and lock the screws in place. During installation, avoid severe impact on the magnetic switch to prevent damage to the internal magnetic reed.
13. The magnetic switch operates by sensing magnetic lines of force. Therefore, when installing, be sure to avoid magnetic fields or magnetic conductive metals within 10cm around to prevent interference with normal operation.
14. When installing the magnetic switch, the leads or entry ports must face downwards.
15. When wiring, be careful not to let the cable come into contact with high-temperature objects.
16. When the load of the magnetic switch is an inductive or capacitive load, a RC circuit should be connected in parallel at the contact ends to protect the contacts.
17. When installing the magnetic switch, it should be close to the indicator and closely attached to the pipe wall.
18. Before powering on, please recheck the wiring to ensure it is correct to avoid accidental damage to the magnetic switch.
19. The direction of the fixing holes of the connection flange of the equipment must be the same as that of the flange fixing holes of the liquid level gauge. The installation direction of the flange fixing holes.
20. If the C-C length of the plastic standard type exceeds 1.5m, it is recommended to add a fixing bracket during installation. The spacing between the fixing brackets and the installation flange should not exceed 1m. The type of the fixing bracket will vary depending on the site environment. If necessary, the company can make it. Please indicate the requirement for the fixing bracket in the order.
21. Before installation, remove the two dust cover covers in the upper and lower installation flanges of the product.